Wednesday, March 19, 2014

MySQL Cluster on Raspberry Pi - Sub-second failover

MySQL Cluster claims to achieve sub-second failover without any data loss for commited transactions. And I always wanted to show this in a demo. Now we created that demo finally. See Mark's blog and Keith's blog for setting up MySQL Cluster on RaspberryPi.
The nice thing about the RPis is that you can easily pull the plug to test failover. Ok, that is only one possible failure scenario but for sure the most obvious and more impressive than "kill -9".


That demo application is constantly using the database for storing new lines, removing old lines and reading all line data for the graphical view. There is no caching. It uses JDBC directly.
To document the setup here is the config.ini file for MySQL Cluster:
[ndb_mgmd]
hostname=192.168.0.101
NodeId=1

[ndbd default]
diskless=1
noofreplicas=2
DataMemory=2M
IndexMemory=1M
DiskPageBufferMemory=4M
StringMemory=5
MaxNoOfConcurrentOperations=1K
MaxNoOfConcurrentTransactions=500
SharedGlobalMemory=500K
LongMessageBuffer=512K
MaxParallelScansPerFragment=16
MaxNoOfAttributes=100
MaxNoOfTables=20
MaxNoOfOrderedIndexes=20
HeartbeatIntervalDbDb=10
[ndbd]
hostname=192.168.0.6
datadir=/home/pi/mysql/ndb_data
NodeId=3

[ndbd]
hostname=192.168.0.11
datadir=/home/pi/mysql/ndbd_data
NodeId=4

[mysqld]
NodeId=50
I made the cluster diskless so it will not write any logs and table spaces to disk. The SD card performance was not great and it does not affect failover behavior.
I also reduced the HeatbeatIntervallDbDb so that nodes detect immediately (well, 10ms) if a heartbeat is missed. After a few missed heartbeats cluster reconfigures and the remaining node takes responsibility and service continues.
BTW: Pulling the plug is nice but every now and then I had to manually fsck the root-fs during reboot.

No comments:

Post a Comment